AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
![]() ![]() Note: As you can see above, this is going to publish the report using the same XML output, we created in the previous section. Enter the path of the file in Test Report XMLs. Save the changes and click on Build Now to build the project again. Select Publish JUnit Test Result Report.Go to Post-Build Actions. So this is something that will be looked by Jenkins after the build has been completed.So in the next section we will try to achieve the same. By writing the commands in Post-Build Actions, we tell Jenkins about the work it has to do after the build part is completed. Since a report can only be published after the build, hence publishing report becomes a part of Post-Build Actions. Whenever we want to publish the report, we need to explicitly tell Jenkins about it. This is also called publishing the report. This report is in XML format and is the raw code which will be used by Jenkins to draw graphical representation of the report. Now, this file contains the xml code of the report. You can open the file and see the test results being written in XML format. You will see that the report has been created. In the Workspace you will see that a new folder has already been created by the name you specified.ģ.Click on the folder.Note: Build is done from the left side navigation by clicking on Build Now, which is available at the root folder of the Jenkins Job/Project. On completion of the build, go to Workspace folder. To generate the execution output, we need to build the project with the above configurations.How to View the XML Results/Output generated by Jenkins? Note: If the folder specified is not available then it will be automatically created inside the Workspace at Jenkins directory. reporter-junit-export "newman/myreport.xml" To mention the directory to save the report, type the following in the continuation of above command: How to Specify the Path to save Newman report on Jenkins? So it is better that you write in continuation or if you want to write one line after another then always specify " \" after each end of the line as I will show you in the next step. It is also noteworthy to see that when you press enter and write the next command, Jenkins does not read the third line and in some systems not even second line. cli,junit should be written without any spaces. Note: It is very important to note that there is only one space which is after "-reporters". Command to Generate CLI & JUNIT reports: -reporters cli,junit.Command to Run Collection using Newman: newman run.Navigate to Configure -> Build section and write the below command in the continuation of the command to run collection using Newman. How to Generate CLI & JUNIT Newman report on Jenkins? I hope you are inside the Jenkins Job/Project and the following screen is visible to you at your system. Refer tutorial How to Run Postman Collections on Jenkins? Jenkins Job configured to run Postman Collections. ![]() Refer tutorial How to Install & Start Jenkins? There are different kinds of reporters available in the Newman but we will be using CLI and JUNIT reporters in this tutorial. It is very important to know that we need to specify the output path for the report, or else the report will be saved somewhere automatically. How to Generate Newman Reports on Jenkins? At the official documentation of Newman, few of the report generating commands are specified. This written report can be in different formats and these can be managed by specifying along with the build command. Jenkins reports are just not graphical but can produce the detail written reports. ![]() As mentioned above there are many plugins available for the same. Reports also work easier when we have to communicate the results with our team members or with other stake holders.
0 Comments
Read More
Leave a Reply. |